1、自动上料搅拌车在冷车状态下启动发动机,需对发动机进行必要的预热,发动机在正常的工作温度下,其零件之间的运转阻力、磨损、工作稳定性等方面是的。所以进行预热是必要的。
1. It is necessary to preheat the engine when the automatic charging mixer starts the engine in the cold state. Under the normal working temperature of the engine, the running resistance, wear and working stability between the parts are the best. So preheating is necessary.
2、自动上料搅拌车在驾驶车辆的过程中,注意观察仪表上的有关指示,时常观察水温表、机油灯、充电指示灯的提示。搅拌车运输车发现有不良现象即刻处理。
2. In the process of driving the automatic feeding mixer, pay attention to the relevant instructions on the instrument, and often observe the tips of the water temperature gauge, engine oil lamp and charging indicator light. If the mixer truck is found to be defective, it shall be handled immediately.
3、自动上料搅拌车行驶中尽量让发动机转速在转速表的红刻度以下区,避免发动机超负荷运行,手动挡的车辆尽可能不要拖挡。
3. During the operation of the automatic feeding mixer, the engine speed should be below the red scale of the tachometer as far as possible, so as to avoid the overload operation of the engine, and the manual gear vehicle should not be stalled as far as possible.
4、自动上料搅拌车定期保养发动机,按时按里程对发动机进行保养,选用合适的发动机机油。保持冷却液的清洁,使发动机有良好的散热性。定期对发动机的油路和气路进行清洗。搅拌车油泵维修保证发动机有畅通的进油、进气通道。
4. The engine of the automatic feeding mixer shall be maintained regularly, and the engine shall be maintained according to the mileage on time, and the appropriate engine oil shall be selected. Keep the coolant clean so that the engine has good heat dissipation. Clean the oil and gas lines of the engine regularly. The maintenance of the oil pump of the mixer ensures that the engine has smooth oil inlet and air inlet channels.
5、自动上料搅拌车油箱中燃油的加注量尽量保持在剩下1/3时即进行加油,以使油箱中的汽油泵良好地散热,保证汽油泵有足够长的寿命。
5. The filling amount of fuel in the tank of the automatic feeding mixer truck should be kept at 1 / 3 of the remaining volume as far as possible, so as to make the gasoline pump in the tank well dissipate heat and ensure the long service life of the gasoline pump.
6、自动上料搅拌车要使用符合规定的燃油。燃油的质量对发动机的燃烧影响很大,劣质的汽油会使燃烧室、喷油器、进气道及气门等处产生大量的积炭和积胶,搅拌车减速机油封使发动机出现怠速不稳、加速困难等现象。
6. The automatic feeding mixer should use fuel that meets the requirements. The quality of fuel has a great influence on the combustion of the engine. The inferior gasoline will cause a lot of carbon and glue deposit in the combustion chamber, fuel injector, intake port and valve. The oil seal of the reducer of the mixer makes the engine unstable at idle speed and difficult to accelerate.
7、自动上料搅拌车在安静的状态下启动发动机让发动机怠速和加速运行,听发动机的声音是否正常。搅拌车油泵维修正常发动机运行声音应该是比较低沉而有规律的,如果出现比较尖锐的声响,请立即去维修厂进行诊断,以避免故障造成更大的损坏。
7. The automatic feeding mixer starts the engine in a quiet state, let the engine idle and accelerate running, listen to the sound of the engine is normal. The oil pump of the mixer truck is maintained normally, and the engine running sound should be relatively low and regular. If there is a sharp noise, please go to the maintenance plant for diagnosis immediately, so as to avoid greater damage caused by the fault.
I believe that read the automatic concrete mixer truck http://www.sqjituan.cn After the introduction, we will have our own understanding of this aspect and solve the problems in the future.